[1]朱满林,石成英,蔡星会,等.基于ICP技术的炸药冲击波压力测定[J].爆破器材,2012,41(04):30-32.
　ZHU Manlin,SHI Chengying,CAI Xinghui,et al.Shock Wave Pressure Measurement of Explosive Based on ICP Technology[J].EXPLOSIVE MATERIALS,2012,41(04):30-32.
点击复制

基于ICP技术的炸药冲击波压力测定()
分享到：

《爆破器材》[ISSN:1001-8352/CN:32-1163/TJ]

卷:
41
期数:
2012年04
页码:
30-32
栏目:
出版日期:
2012-08-20

文章信息/Info

Title:
Shock Wave Pressure Measurement of Explosive Based on ICP Technology
文章编号:
4445
作者:
朱满林; 石成英; 蔡星会; 王效廉
第二炮兵工程大学（陕西西安，710025）
Author(s):
ZHU Manlin;  SHI Chengying;  CAI Xinghui;  WANG Xiaolian
The Second Artillery Engineering University (Shaanxi Xi’an, 710025)
关键词:
冲击波; 峰值超压; ICP技术; 测定
Keywords:
shock wave;  peak overpressure;  ICP technology;  measurement
分类号:
TQ560.72 TJ510.6
文献标志码:
A
摘要:
采用由137型传感器、VXI数据采集和计算机数据处理系统等组成的测定炸药自由场冲击波压力的高速动态测量系统，测得了某传爆药柱在空中爆炸时产生的空气冲击波超压曲线，并通过计算和数据拟合方法，得到了超压曲线、超压随时间变化的关系式以及不同条件下的峰值超压、正压作用时间等参数。实验表明：随着测点爆心距的增大，峰值超压递减，且测点爆心距越大，超压衰减速率越小。当爆心距为0.6m时，超压值为0.1143 MPa，而当距离为1.2 m时，超压值则为0.0323 MPa。
Abstract:
This article introduced a high speed dynamic system composed of a type 137 sensors, a VXI data acquisition and a computer data processing, which could be used to measure explosive shock wave in the free field. With calculation and the data fitting method, the super pressure curve, the relationships about overpressure changing with the time, and parameters of the peak overpressure duration and specific impulse in different conditions could be obtained. The experimental results indicate that the peak overpressure is reduced with the increase of distance between measuring point and exploding point, and the further the distance, the less the decay rate of overpressure. The overpressures are 0.1143 and 0.0323 MPa when the distances are 0.6 and 1.2 m, respectively.

参考文献/References:

［1］PCB Piezotronics Inc.ICP Dynamic Pressure Sensor Installation and Operating Manual［M］.USA: 1998.
［2］PCB Piezotronics Inc. Manual 482C05 Series Installation and Operating Manual［M］.USA: 2002.
［3］Wu C.,Hao H.Modeling of Simultaneous Ground Shock and Air Blast Pressure on Nearby Structures from Surface Explosions［J］.Int.J Impact Eng.,2005,31(6):699717.
［4］Bulson P.S.Explosive Loading of Engineering Structures［M］.Abingdon:Spon,1997.
［5］杨鑫,石少鑫,程鹏飞.空气中TNT爆炸冲击波超压峰值的预测及其数值模拟［J］.爆破,2008,25(1):15-19.
［6］成凤生，宋浦，顾晓辉，等.TNT装药爆炸波在刚性平面上方传播反射的数值研究［J］.爆破器材，2011，40（4）：1-4.
［7］解立峰，韩志伟，王海洋，等.民用炸药敏感度试验方法的研究与探讨［J］.爆破器材，2011，40（2）：8-10.
［8］宁建国，王成，马天宝 .爆炸与冲击动力学［M］.北京：国防工业出版社，2010:113-115.
［9］姚熊亮，刘向东，庞福振，等.球面加载法在航船舱室爆炸破坏环境中的应用［J］.哈尔滨工程大学学报， 2006,27(5):693-697.
［10］张挺.爆炸冲击波测量技术［M］.北京：国防工业出版社，1984：5-13.
［11］孔惠萍.压电式传感器、VXI总线采集系统测试爆炸物冲击波研究［J］.传感器世界，2005，11（5）：14-16.
［12］程祥,杨明,郭亚丽，等.修正的Friedlander方程指数衰减因子［J］.爆炸与冲击.2009（4）：425-428.

相似文献/References:

[1]史长根,洪津,蒋国良,等.爆炸焊接危害机理分析[J].爆破器材,2009,38(03):28.
　SHI Changgen,HONG Jin,JIANG Guoliang,et al.Harm Mechanism Analysis of Explosive Welding[J].EXPLOSIVE MATERIALS,2009,38(04):28.
[2]史长根,尤峻,周祥,等.高压容器试验仓安全评估计算方法研究[J].爆破器材,2011,40(04):32.
　SHI Changgen,YOU Jun,ZHOU Xiang,et al.Study on Computational Method of Safe Evaluation for Test House of High Pressure Gases Vessel Explosion Hazards[J].EXPLOSIVE MATERIALS,2011,40(04):32.
[3]徐全军①,渠银录①,姜楠①,等.某炸药库内爆作用下坑道内隔爆防护墙厚度估算[J].爆破器材,2012,41(02):34.
　XU Quanjun,QU Yinglu,JIANG Nan,et al.Thickness Calculation of Tunnel Explosion Protection Wall under the Blasting Destroy in Explosive Magazine[J].EXPLOSIVE MATERIALS,2012,41(04):34.
[4]连赟猛①,方道红②,顾晓辉①,等.典型密闭装置内爆炸尺寸效应研究[J].爆破器材,2012,41(05):1.
　LIAN Yunmeng,FANG Daohong,GU Xiaohui,et al.Effect of Scales on Typical Closed Structure Due to Internal Explosion[J].EXPLOSIVE MATERIALS,2012,41(04):1.
[5]李鸿宾,王建灵,张为鹏,等.铝粉比表面积与质量分数对浆状温压炸药爆炸冲击波影响的实验研究[J].爆破器材,2013,42(01):5.[doi:10.3969/j.issn.1001-8352.2013.01.002]
　LI Hongbin,WANG Jianling,ZHANG Weipeng,et al.Experiment Study on the Effect of Specific Surface Area and Content of Aluminum Powder on Shock Wave Output of Slurry TBE[J].EXPLOSIVE MATERIALS,2013,42(04):5.[doi:10.3969/j.issn.1001-8352.2013.01.002]
[6]杨亚东,李向东,王晓鸣.爆炸冲击波空中传播特征参量的优化拟合[J].爆破器材,2014,43(01):13.[doi:10.3969/j.issn.1001-8352.2014.01.003]
　YANG Yadong,LI Xiangdong,WANG Xiaoming.Optimum Fitting for Characteristic Parameters of Blast Shockwaves Traveling in Air[J].EXPLOSIVE MATERIALS,2014,43(04):13.[doi:10.3969/j.issn.1001-8352.2014.01.003]
[7]胡宏伟①,鲁忠宝②,郭炜①,等.水中爆炸的殉爆试验方法[J].爆破器材,2014,43(03):25.[doi:10.3969/j.issn.1001-8352.2014.03.006]
　HU Hongwei,LU Zhongbao,GUO Wei,et al.The Method of Sympathetic Detonation Experiment in Water[J].EXPLOSIVE MATERIALS,2014,43(04):25.[doi:10.3969/j.issn.1001-8352.2014.03.006]
[8]夏永乐①②,张志杰①②,翟永①②,等.基于FPGA+ARM+WIFI的炸药冲击波超压采集系统设计[J].爆破器材,2015,44(01):55.[doi:10.3969/j.issn.1001-8352.2015.01.013]
　XIA Yongle,ZHANG Zhijie,ZHAI Yong,et al.Design of Explosive Acquisition System for Shock Wave Overpressure Based on FPGA+ARM+WIFI[J].EXPLOSIVE MATERIALS,2015,44(04):55.[doi:10.3969/j.issn.1001-8352.2015.01.013]
[9]史长根,尤峻.双立式爆炸焊接新方法[J].爆破器材,2008,37(03):28.
　Shi Changgen,You Jun.New Technology of Double Vertical Explosive Welding[J].EXPLOSIVE MATERIALS,2008,37(04):28.
[10]严家佳,贾宪振,任松涛.一种传感器结构对水中爆炸冲击波影响的数值模拟研究[J].爆破器材,2016,45(01):7.[doi:10.3969/j.issn.1001-8352.2016.01.002]
　YAN Jiajia,JIA Xianzhen,REN Songtao.Numerical Simulation of Underwater Explosion Shock Wave Influenced by the Structure of One Sensor[J].EXPLOSIVE MATERIALS,2016,45(04):7.[doi:10.3969/j.issn.1001-8352.2016.01.002]

备注/Memo

备注/Memo:
收稿日期：2011-12-27
作者简介：朱满林（1962~），男，硕士，高级实验师，主要从事战斗部工程技术研究。
更新日期/Last Update: 2012-08-31