[1]孙晨,夏光,赵晓莉,等.不同测试条件下炸药爆炸后有毒气体含量的差异研究[J].爆破器材,2022,51(06):22-26.[doi:10.3969/j.issn.1001-8352.2022.06.004]
　SUN Chen,XIA Guang,ZHAO Xiaoli,et al.Study on the Difference of Toxic Gas Production in Explosive Explosion under Different Test Conditions[J].EXPLOSIVE MATERIALS,2022,51(06):22-26.[doi:10.3969/j.issn.1001-8352.2022.06.004]
点击复制

不同测试条件下炸药爆炸后有毒气体含量的差异研究()
分享到：

《爆破器材》[ISSN:1001-8352/CN:32-1163/TJ]

卷:
51
期数:
2022年06
页码:
22-26
栏目:
爆炸材料
出版日期:
2022-11-25

文章信息/Info

Title:
Study on the Difference of Toxic Gas Production in Explosive Explosion under Different Test Conditions
文章编号:
5733
作者:
孙晨; 夏光; 赵晓莉; 何振; 王傲; 杨文
中煤科工集团淮北爆破技术研究院有限公司检测中心 （安徽淮北，235100）
Author(s):
SUN Chen;  XIA Guang;  ZHAO Xiaoli;  HE Zhen;  WANG Ao;  YANG Wen
Testing Center, Huaibei Blasting Technology Research Institute Co., Ltd., China Coal Science and Industry Group (Anhui Huaibei, 235100)
关键词:
工业炸药; 大爆炸箱测试装置; 小弹筒测试装置; 有毒气体含量
Keywords:
industrial explosives;  large explosion box test device;  small cartridge test device;  toxic gas content
分类号:
TQ560.7
DOI:
10.3969/j.issn.1001-8352.2022.06.004
文献标志码:
A
摘要:
为研究在不同测试条件下工业炸药爆炸后有毒气体含量的差异，分别利用大爆炸箱常压测试装置和传统小弹筒测试装置对工业炸药进行起爆测试，分析比较了测试结果。结果表明：两种测试条件下测得的炸药爆炸后有毒气体含量存在明显差异，大爆炸箱中的有毒气体含量低于小弹筒中含量。在小弹筒测试条件下，现场混装炸药较难达到完全爆轰，导致炸药产生大量的有毒气体；说明传统小弹筒测试方法对于现场混装炸药爆炸后有毒气体含量的测试相对局限。研究结果对于工业炸药尤其是现场混装炸药爆炸后有毒气体含量测试方法的完善和建立提供理论支撑。
Abstract:
In order to study the difference of toxic gas production in explosion of industrial explosives under different test conditions, the detonation test of industrial explosives was carried out by using the atmospheric pressure test device of the large explosion box and the traditional small cartridge test device, respectively. Test results were analyzed and compared. Results show that there are obvious differences in output of explosive toxic gas measured by the two test devices. Toxic gas test results of the explosive in the large explosion box are lower than those in the small cartridge. In addition, under the test conditions of small cartridges, it is difficult to achieve complete detonation for mixed explosives on site, resulting in the generation of a large amount of toxic gas from the explosives. Furthermore, it is explained that the traditional small cartridge test method is relatively limited for the toxic gas test of mixed explosives on site. The research results provide theoretical support for the improvement and establishment of the test method for the toxic gas production of industrial explosives, especially mixed explosives on site.

参考文献/References:

［1］李志军, 石小军, 张成勇. 混装炸药在川藏铁路隧道爆破施工的应用探讨［J］. 隧道建设(中英文), 2021, 41(增刊2): 479-484.
LI Z J， SHI X J， ZHANG C Y. Application of mixed explosives in tunnel blasting construction in Sichuan-Tibet Railway ［J］.Tunnel Construction, 2021, 41(Suppl.2): 479-484.
［2］李大财, 何春辉. 露天混装乳化炸药和药卷包装炸药在金属矿山的应用比较［J］.世界有色金属, 2016(12): 91-92.
LI D C, HE C H. In the open air mixed loading emulsion explosive and the explosive cartridge packaging the application of metal mine ［J］.World Nonferrous Metals, 2016(12): 91-92.
［3］金庆军. 煤矿乳化炸药爆炸有毒气体探究［J］.山东煤炭科技,2022, 40(3): 195-197.
JIN Q J. Study on toxic gas of emulsion explosive explosion in coal mine ［J］.Shandong Coal Science and Technology, 2022, 40(3): 195-197.
［4］高贫, 潘峰. 工业炸药有毒气体含量测定的影响因素［J］. 爆破器材, 2014, 43(6): 30-34.
GAO P, PAN F. Factors affecting the measurement of toxic gases produced by industrial explosives［J］. Explosive Materials, 2014, 43(6): 30-34.
［5］吴国群. 煤矿许用炸药爆炸后有毒气体含量的实验测定［J］. 煤炭技术, 2014, 33(5): 294-295.
WU G Q. Determination of toxic gases content formed by detonation of permissible explosive ［J］.Coal Technology, 2014, 33(5): 294-295.
［6］彭云昆. 浅析影响工业炸药爆炸后有毒气体含量的因素［J］. 爆破器材, 2010, 39(4): 35-38.
PENG Y K. Analysis of factors influencing the content of toxic gases after industrial explosive explosion ［J］. Explosive Materials, 2010, 39(4): 35-38.
［7］刘丽梅, 宁平, 吕春绪. 工业炸药爆炸后有毒气体含量测定方法标准的讨论［J］.工程爆破, 2010,16(1): 74-77.
LIU L M,NING P,Lǔ C X.Discussion on determination standard of toxic gas volume formed by detonation of industrial explosive［J］. Engineering Blasting, 2010,16(1): 74-77.
［8］高玉刚. 工业炸药有毒气体测试容器的研制［J］.工程爆破, 2021, 27(4): 114-117, 123.
GAO Y G. Development of toxic gas test vessel for industrial explosives ［J］.Engineering Blasting, 2021, 27(4):114-117, 123.
［9］孙晨. 多孔粒状铵油炸药爆炸后有毒气体含量的常压测试方法［J］. 爆破器材, 2022, 51(1): 60-64.
SUN C. Test method for volume of toxic gas produced by explosion of porous granular ammonium explosive at atmosperic pressure ［J］.Explosive Materials, 2022, 51(1): 60-64.
［10］孙晨. 异形容器JCBN500G有毒气体爆炸箱容积标定方法［J］. 煤矿爆破, 2021, 39(3): 6-10.
SUN C.Volume calibration method of JCBN500G shaped container for toxic gas explosion ［J］.Coal Mine Blasting, 2021, 39(3): 6-10.
［11］徐龙, 姚银梅, 赵晓莉. 钢炮扩孔对小直径炸药有毒气体含量测定结果的影响［J］. 煤矿爆破, 2005(4): 15-16.
XU L, YAO Y M, ZHAO X L. Discussions on the expanding effect of cannon on the measurement result of noxious gases from small diameter explosive tube ［J］. Coal Mine Blasting, 2005(4): 15-16.

相似文献/References:

[1]黄寅生,刘杰,曾志超.硝酸铵水溶液浓度快速检测方法[J].爆破器材,2011,40(01):16.
　HUANG Yinsheng LIU Jie ZENG Zhichao.Rapid Detection Methods of Ammonium Nitrate Solution Concentration[J].EXPLOSIVE MATERIALS,2011,40(06):16.
[2]李长发,吴文慧,顾靖,等.一种测定工业炸药爆速新方法的研究[J].爆破器材,2011,40(01):28.
　LI Changfa,WU Wenhui,GU Jing,et al.A New Determination Method for Detonation Velocity of Industrial Explosive[J].EXPLOSIVE MATERIALS,2011,40(06):28.
[3]徐德安.液体硝酸铵直接应用于工业炸药生产的效益分析[J].爆破器材,2011,40(01):32.
　Xu Dean.Benefit Analysis on the Application of Ammonium Nitrate Solution Directly in the Industry Explosive Production[J].EXPLOSIVE MATERIALS,2011,40(06):32.
[4]陈中亿.工业炸药悬挂式轨道输送车系统的安全性研究[J].爆破器材,2010,39(05):34.
　CHEN Zhongyi.Study the Safety of Hanging Orbital Transport Vehicle System for Industrial Explosives[J].EXPLOSIVE MATERIALS,2010,39(06):34.
[5]姜卫国,李全华,李怀刚,等.基于市场需求的工业炸药自动中包生产线的模块化设计[J].爆破器材,2010,39(06):30.
　JIANG Weiguo,LI Quanhua,LI Huaigang,et al.Modular Design of the Explosive Auto-packaging Line Based on Market Demand[J].EXPLOSIVE MATERIALS,2010,39(06):30.
[6]金娥,唐芳,李克升.工业炸药有关设备运转过程中的能量与安全[J].爆破器材,2009,38(06):17.
　JIN E,TANG Fang,LI Kesheng.Energy and Security of the Equipments in the Industrial Explosive Production Process[J].EXPLOSIVE MATERIALS,2009,38(06):17.
[7]宋少云.,张国全.,巫纯辉,等.工业炸药裹包装置上翻包机构的图解法设计[J].爆破器材,2009,38(04):33.
　SONG Shaoyun.,ZHANG Guoquan.,WU Chunhui,et al.Graphical Method Design of Turning Package Mechanism in Wrapping Machine of Industrial Explosive[J].EXPLOSIVE MATERIALS,2009,38(06):33.
[8]韩修栋,熊代余,查正清,等.工业炸药现场混装系统的新进展[J].爆破器材,2009,38(03):8.
　HAN Xiudong,XIONG Daiyu,ZHA Zhengqin,et al.New Development of Industrial Explosive Site-mixing System[J].EXPLOSIVE MATERIALS,2009,38(06):8.
[9]陆明.提高硝酸铵炸药威力的途径研究[J].爆破器材,2011,40(05):1.
　LU Ming.Study on the Improving Strength for Ammonium Nitrate Explosive[J].EXPLOSIVE MATERIALS,2011,40(06):1.
[10]徐海波①,何小敏①,刁建彬②,等.工业炸药药卷传输姿态在线检测方法[J].爆破器材,2012,41(06):19.[doi:10.3969/J.ISSN.1001-8532.2012.06.006]
　XU Haibo,HE Xiaomin,DIAO Jianbin,et al.On-line Inspection Method for the Transmission Profile of Industrial Explosive Cartridges[J].EXPLOSIVE MATERIALS,2012,41(06):19.[doi:10.3969/J.ISSN.1001-8532.2012.06.006]

备注/Memo

备注/Memo:
收稿日期：2022-06-11
第一作者：孙晨（1992－），男，硕士，助理工程师，主要从事民用爆破器材安全与性能的基础研究及检测。E-mail:117525575@qq.com
更新日期/Last Update: 2022-11-21