[1]郭可伟,宋阿青.双重预裂与定向抛掷爆破相结合在露天煤矿削坡减载工程中的应用[J].爆破器材,2017,46(05):60-64.[doi:10.3969/j.issn.1001-8352.2017.05.013]
　GUO Kewei,SONG aqing.Combination of Double Pre-splitting Blasting and Directional Throwing Blasting in Slope Cutting and Unloading Engineering of Open Pit Coal Mine[J].EXPLOSIVE MATERIALS,2017,46(05):60-64.[doi:10.3969/j.issn.1001-8352.2017.05.013]
点击复制

双重预裂与定向抛掷爆破相结合在露天煤矿削坡减载工程中的应用()
分享到：

《爆破器材》[ISSN:1001-8352/CN:32-1163/TJ]

卷:
46
期数:
2017年05
页码:
60-64
栏目:
爆破技术
出版日期:
2017-09-25

文章信息/Info

Title:
Combination of Double Pre-splitting Blasting and Directional Throwing Blasting in Slope Cutting and Unloading Engineering of Open Pit Coal Mine
文章编号:
5147
作者:
郭可伟；宋阿青
葛洲坝易普力新疆爆破工程有限公司（新疆乌鲁木齐，830000）
Author(s):
GUO Kewei;  SONG aqing
Xinjiang Blasting Engineering Branch, Explosive Co., Ltd., Gezhouba Group (Xinjiang Urumqi, 830000)
关键词:
削坡减载; 抛掷爆破; 双重预裂爆破; 预留岩体
Keywords:
slope cutting and unloading;  throwing blasting;  double pre-splitting blasting;  rock reservation
分类号:
TD235
DOI:
10.3969/j.issn.1001-8352.2017.05.013
文献标志码:
A
摘要:
通过双重预裂爆破和定向抛掷爆破相结合，将高边坡危岩爆破抛掷至指定位置，起到削坡减载的作用。同时，利用双重预裂爆破稳定预留岩体。相对于传统预裂爆破，双重预裂爆破能更好地减弱抛掷爆破对预裂边坡的损坏，在主炮孔起爆前沿开口线形成一层1.0 m左右的破碎带；相对于传统预裂孔形成的预裂缝，保护预留岩体的作用更加明显；与目前使用预裂爆破或者抛掷爆破常规手段进行削坡减载相比，具有效率高、成型快、边坡稳定性好的优点。在黑山煤矿二期削坡减载工程中的实际运用中，一次削坡工程量达30×104m3，边坡成型面积达1×104m2以上。
Abstract:
Double pre-splitting blasting and directional throw blasting were combined in slope cutting and unloading engineering by removing dangerous rock from high slope site to the assigned area. At the same time, the reserved rock was stabilized using double pre-splitting blasting. Compared with traditional pre-splitting blasting, double pre-split blasting could reduce the damage of slope due to throwing blasting by the formation of a layer of 1.0 m broken zone around the opening line before the explosion of the main holes. Compared with pre-cracking formed by traditional pre-splitting blasting, the protection of retaining rock is much more obvious. And compared with double presplitting blasting or directional throw blasting used in slope cutting and unloading, this method has the advantages of high efficiency, fast forming, and the good stability of the slope. It has been used in the second phase of slope cutting and unloading engineering in Heishan Coal Mine. Results show that the engineering quantity of slope cutting is up to 30×104m3, and the slope forming area is more than 1×104m2.

参考文献/References:

［1］祝文化,涂胜,刘晓华.高边坡无马道切槽开挖控制爆破［J］.爆破，2001,18(增刊1)：27-29.
ZHU W H,TU S, LIU X H. Controlled blasting excavation of high slope notch［J］. Blasting, 2001,18(Suppl.1)：27-29.
［2］于亚伦.工程爆破理论与技术［M］.北京：冶金工业出版社, 2004.
［3］张正宇,刘美山,吴从清.高陡边坡开挖中的爆破及其控制技术［M］//张正宇.中国爆破新技术.北京：冶金工业出版社,2004:98-101.
［4］SOEJIMA M ASAKUMA Y,MORI T, et al. Analysis of the influence of crack in coke on the fracture［J］.Testu to Hagane, 2001,87:245-251.
［5］孙金龙.大型露天煤矿半连续工艺应用范围研究［D］.徐州：中国矿业大学, 2013. 
SUN J L.Application range research on semi-continuous mining system in large open-pit coal mines［D］.Xuzhou: China University of Mining and Technology, 2013. 
［6］宫玉成.哈尔乌素露天煤矿单斗-卡车工艺优化研究［D］.包头：内蒙古科技大学, 2013. 
 GONG Y C. Optimization study in Harwusu surface mine single bucket excavator-truck system ［D］. Baotou: Inner Mongolia University of Science and Technology,2013. 
［7］李本平,刘聪,王双利,等.松散介质抛掷爆破试验研究［J］.爆破,2010,27(1):11-13. 
 LI B P,LIU C,WANG S L, et al. Experimental study on cast blasting in loose medium ［J］.Blating, 2010,27 (1): 11-13. 
［8］陈士海,王明洋,赵跃堂,等.岩石爆破破坏界面上的应力时程研究［J］.岩石力学与工程学报,2003,22(11):1784-1788. 
 CHEN S H.WANG M Y.ZHAO Y T, et al. Time-stress history on interface between cracked and uncracked zones under rock blasting［J］. Chinese Journal of Rock Mechanics and Engineering, 2003,22 (11): 1784-1788. 
［9］颜事龙.现代工程爆破理论与技术［M］.徐州：中国矿业大学出版社，2007:137.
［10］丁小华,李克民,狐为民,等.基于非线性理论的抛掷爆破爆堆形态预测［J］.中国矿业大学学报,2012,41(5):764-769. 
DING X H,LI K M,HU W M, et al.Prediction of optimum muck pile casting shape during blasting: a non linear theory［J］. Journal of China University of Mining and Technology, 2012,41 (5): 764-769.
［11］刘振华．中华人民共和国强制性条文矿山工程部分实施手册［M］． 哈尔滨: 黑龙江科学技术出版社，2003．
［12］MOHR S H, EVANS G M. Forecasting coal production until 2100［J］. Fuel, 2009, 88（11）：2059-2067 .
［13］刘殿中，杨仕春.工程爆破实用手册［M］. 北京：冶金工业出版社,1999. 
［14］OUCHTERLONY F. Prediction of crack lengths in rock after cautions blasting with zero inter-hole delay［J］. Fragblast:International Journal for Blasting and Fragmentation,1997,1(4):417-444.

相似文献/References:

[1]宋日,冯宁.I-kon 数码雷管在露天煤矿抛掷爆破技术中的应用[J].爆破器材,2009,38(04):28.
　SONG Ri,FENG Nin.Application of Ikon Digital Detonator System on the Cast Blasting in Open Cut[J].EXPLOSIVE MATERIALS,2009,38(05):28.
[2]李玉清,宋日,李渊,等.露天矿高台阶抛掷爆破炸药配方设计及现场制备[J].爆破器材,2013,42(03):37.[doi:10.3969/j.issn.1001-8352.2013.03.009]
　LI Yuqing,SONG Ri,LI Yuan,et al.Design and Onsite Preparation of Explosives Used for High Step Casting Blast in Open-pit Mine[J].EXPLOSIVE MATERIALS,2013,42(05):37.[doi:10.3969/j.issn.1001-8352.2013.03.009]

备注/Memo

备注/Memo:
收稿日期：2017-02-08
作者简介：郭可伟（1984－），男，中级爆破工程师，研究方向为矿山爆破技术。E-mail:251968814@qq.com
更新日期/Last Update: 2017-09-25